• metric rib-scale—This command was introduced.
• metric—The picoseconds keyword was added.
• metric weights—Support was added for the k6 constant.
• show eigrp interfaces—The command output was modified to display relevant wide metric information.
• show eigrp neighbors —The command output was modified to display relevant wide metric information.
• show eigrp topology—The command output was modified to display relevant wide metric information.
• show protocols—The command output was modified to display relevant wide metric information.
If there is a combination of IOS and IOS-XR PE devices in the network, then the EIGRP wide metric
must be disabled in IOS-XR PE device. This is because the method of calculating metrics in L3VPN
design between IOS and IOS-XR.
Note
EIGRP Multi-Instance
The Enhanced Interior Gateway Routing Protocol (EIGRP) Multi-Instance feature allows multiple process
instances to handle different routing instances and service the same VRF. Each process instance handles the
routing instances configured under it. The multiple EIGRP process instance implementation allows to configure
the EIGRP using a virtual-name in addition to an autonomous-system number.
How to Implement EIGRP
This section contains instructions for the following tasks:
To save configuration changes, you must commit changes when the system prompts you.Note
Enabling EIGRP Routing
This task enables EIGRP routing and establishes an EIGRP routing process.
Before You Begin
Although you can configure EIGRP before you configure an IP address, no EIGRP routing occurs until at
least one IP address is configured.
Cisco ASR 9000 Series Aggregation Services Router Routing Configuration Guide, Release 5.1.x
OL-30423-03 253
Implementing EIGRP
EIGRP Multi-Instance
To Next Page
Loading...
Need help?
General
