Sample Output for the show ospf Command After Configuring MPLS TE
In the following example, the show route ospf EXEC configuration command verifies that the MPLS TE
tunnels replaced GigabitEthernet interface 0/3/0/0 and that configuration was performed correctly:
show route ospf 1
O E2 192.168.10.0/24 [110/20] via 0.0.0.0, 00:00:15, tunnel2
O E2 192.168.11.0/24 [110/20] via 0.0.0.0, 00:00:15, tunnel2
O E2 192.168.1244.0/24 [110/20] via 0.0.0.0, 00:00:15, tunnel2
O 192.168.12.0/24 [110/2] via 0.0.0.0, 00:00:15, tunnel2
Configuring OSPFv3 Graceful Restart
This task explains how to configure a graceful restart for an OSPFv3 process. This task is optional.
SUMMARY STEPS
1.
configure
2.
router ospfv3 process-name
3.
graceful-restart
4.
graceful-restart lifetime
5.
graceful-restart interval seconds
6.
graceful-restart helper disable
7.
commit
8.
show ospfv3 [ process-name [ area-id ]] database grace
DETAILED STEPS
PurposeCommand or Action
configure
Step 1
Enters router configuration mode for OSPFv3. The
process name is a WORD that uniquely identifies an
router ospfv3 process-name
Example:
RP/0/RSP0/CPU0:router(config)# router ospfv3 test
Step 2
OSPF routing process. The process name is any
alphanumeric string no longer than 40 characters
without spaces.
Enables graceful restart on the current router.graceful-restart
Example:
RP/0/RSP0/CPU0:router(config-ospfv3)#graceful-restart
Step 3
Specifies a maximum duration for a graceful restart.graceful-restart lifetime
Step 4
Example:
RP/0/RSP0/CPU0:router(config-ospfv3)# graceful-restart
lifetime 120
•
The default lifetime is 95 seconds.
•
The range is 90 to 3600 seconds.
Cisco ASR 9000 Series Aggregation Services Router Routing Configuration Guide, Release 5.1.x
OL-30423-03 387
Implementing OSPF
Configuring OSPFv3 Graceful Restart
To Next Page
Loading...
Need help?
General
