Cisco ASR 9000 Series Configuration Guide

apply set-lpref-prepend(100,101,2)
set community (2:1234) additive
else
set local-preference 125
endif
end-policy
!
route-policy filter-bogons
if destination in bogon then
drop
else
pass
endif
end-policy
!
route-policy common-inbound
apply filter-bogons
set origin igp
set community (2:333)
end-policy
!
route-policy set-lpref-prepend($lpref,$as,$prependcnt)
set local-preference $lpref
prepend as-path $as $prependcnt
end-policy
Use Wildcards For Routing Policy Sets
This section describes examples of configuring routing policy sets with wildcards.
Use Wildcards for Prefix Sets
Use the following example to configure a routing policy with wildcards for prefix sets.
1
Configure the required prefix sets in the global configuration mode.
RP/0/RSP0/CPU0:router(config)# prefix-set pfx_set1
RP/0/RSP0/CPU0:router(config-pfx)# 1.2.3.4/32
RP/0/RSP0/CPU0:router(config-pfx)# end-set
RP/0/RSP0/CPU0:router(config)# prefix-set pfx_set2
RP/0/RSP0/CPU0:router(config-pfx)# 2.2.2.2/32
RP/0/RSP0/CPU0:router(config-pfx)# end-set
2
Configure a route policy with wildcards to refer to the prefix sets.
RP/0/RSP0/CPU0:router(config)# route-policy WILDCARD_PREFIX_SET
RP/0/RSP0/CPU0:router(config-rpl)# if destination in prefix-set* then pass else drop
endif
RP/0/RSP0/CPU0:router(config-rpl)# end-policy
This route policy configuration accepts routes with the prefixes mentioned in the two prefix sets, and drops
all other non-matching routes.
3
Commit your configuration.
RP/0/RSP0/CPU0:router(config)# commit
This completes the configuration of routing policy with wildcards for prefix sets. For detailed information on
prefix sets, see prefix-set, on page 474.
Use Wildcards for AS-Path Sets
Use the following example to configure a routing policy with wildcards for AS-path sets.
Cisco ASR 9000 Series Aggregation Services Router Routing Configuration Guide, Release 5.1.x
OL-30423-03 547
Implementing Routing Policy
Use Wildcards For Routing Policy Sets

Cisco ASR 9000 Series Specifications

General

Series	ASR 9000
Category	Network Router
Modular Design	Yes
Redundancy	Yes (Hardware and Software)
Operating System	Cisco IOS XR
Interfaces/Ports	10G, 40G, 100G, 400G Ethernet
Expansion Slots	Varies by model
Routing Protocol	BGP, OSPF, IS-IS, EIGRP
Management	CLI, SNMP, NETCONF
Power Supply	Redundant
Port Density	Varies by model
Power Supply Options	AC, DC
Memory	Varies by model
Storage	Varies by model
Dimensions	Varies by model
Weight	Varies by model