Cisco ASR 9000 Series Configuration Guide

IPv4 Unicast Topology: Enabled
Adjacency Formation: Running
Prefix Advertisement: Running
Metric (L1/L2): 110/110
Weight (L1/L2): 0/0
MPLS Max Label Stack: 1
MPLS LDP Sync (L1/L2): Disabled/Disabled
Link-Group (L1/L2): Configured/Configured
Metric-Offset (L1/L2):100/100
IPv4 Address Family: Enabled
Protocol State: Up
Forwarding Address(es): 100.5.6.6
Global Prefix(es): 100.5.6.0/24
LSP transmit timer expires in 0 ms
LSP transmission is idle
Can send up to 9 back-to-back LSPs in the next 0 ms
Configure Link Group Interface
Perform this task to configure link group under Intermediate System-to-Intermediate System (IS-IS) interface
and address-family sub-mode:
One IS-IS interface and address-family can specify only one link-group association. The default is for
both levels regardless of the current circuit-type. The link-group association can be specified for one level
only if configured.
Note
SUMMARY STEPS
1.
configure
2.
router isis instance-id
3.
interface type interface-path-id
4.
address-family ipv4 | ipv6 [ unicast ]
5.
link-group link-group-name [ level {1 | 2 } ]
6.
commit
7.
show isis interface
DETAILED STEPS
PurposeCommand or Action
configure
Step 1
Enters IS-IS configuration submode.
router isis instance-id
Example:
RP/0/RSP0/CPU0:router(config)# router isis purple
Step 2
Cisco ASR 9000 Series Aggregation Services Router Routing Configuration Guide, Release 5.1.x
324 OL-30423-03
Implementing IS-IS
ISIS Link Group

Cisco ASR 9000 Series Specifications

General

Brand	Cisco
Model	ASR 9000 Series
Category	Network Router
Language	English