Cisco ASR 9000 Series Configuration Guide

DETAILED STEPS
PurposeCommand or Action
configure
Step 1
Configures a BGP routing process and enters router
configuration mode.
router bgp as-number
Example:
RP/0/RSP0/CPU0:router(config)# router bgp 125
Step 2
•
The as-number argument identifies the
autonomous system in which the router resides.
Valid values are from 0 to 65535. Private
autonomous system numbers that can be used in
internal networks range from 64512 to 65535.
Specifies a neighbor IP address.
neighbor ip-address
Example:
RP/0/RSP0/CPU0:router(config-bgp)# neighbor
10.0.0.20
Step 3
Specifies the address family.address-family { ipv4 unicast | ipv4 multicast | ipv4
labeled-unicast | ipv4 tunnel | ipv4 mdt | ipv6 unicast
Step 4
| ipv6 multicast | ipv6 labeled-unicast | vpnv4 unicast
| vpnv6 unicast }
Example:
RP/0/RSP0/CPU0:router(config-bgp-nbr)#
address-family ipv4 unicast
Attaches the route-policy, which must be well formed
and predefined.
route-policy policy-name { in | out }
Example:
RP/0/RSP0/CPU0:router(config-bgp-nbr-af)#
route-policy example1 in
Step 5
commit
Step 6
Modifying a Routing Policy Using a Text Editor
This task explains how to modify an existing routing policy using a text editor. See Editing Routing Policy
Configuration Elements, on page 531 for information on text editors.
Cisco ASR 9000 Series Aggregation Services Router Routing Configuration Guide, Release 5.1.x
OL-30423-03 543
Implementing Routing Policy
Modifying a Routing Policy Using a Text Editor

Cisco ASR 9000 Series Specifications

General

Series	ASR 9000
Category	Network Router
Modular Design	Yes
Redundancy	Yes (Hardware and Software)
Operating System	Cisco IOS XR
Interfaces/Ports	10G, 40G, 100G, 400G Ethernet
Expansion Slots	Varies by model
Routing Protocol	BGP, OSPF, IS-IS, EIGRP
Management	CLI, SNMP, NETCONF
Power Supply	Redundant
Port Density	Varies by model
Power Supply Options	AC, DC
Memory	Varies by model
Storage	Varies by model
Dimensions	Varies by model
Weight	Varies by model