Cisco ASR 9000 Series Configuration Guide

What to Do Next
These show bgp command output displays information from the dynamic route leaking configuration:
•
Use the show bgp prefix command to display the source-RD and the source-VRF for imported paths,
including the cases when IPv4 or IPv6 unicast prefixes have imported paths.
•
Use the show bgp imported-routes command to display IPv4 unicast and IPv6 unicast address-families
under the default-VRF.
Enabling Selective VRF Download
To enable selective VRF download, configure the svd platform enable command followed by router reload.
Selective VRF download is disabled by default.Note
SUMMARY STEPS
1.
admin
2.
configure
3.
svd platform enable
4.
commit
5.
show svd state
6.
admin
7.
reload location all
8.
exit
9.
show svd role
DETAILED STEPS
PurposeCommand or Action
Enters administration EXEC mode.admin
Example:
RP/0/RSP0/CPU0:router# admin
Step 1
Enters Administrative configuration
mode.
configure
Example:
RP/0/RSP0/CPU0:router(admin)#configure
Step 2
Enables selective VRF download.svd platform enable
Example:
RP/0/RSP0/CPU0:router(admin-config)#svd platform enable
Step 3
Cisco ASR 9000 Series Aggregation Services Router Routing Configuration Guide, Release 5.1.x
152 OL-30423-03
Implementing BGP
Enabling Selective VRF Download

Cisco ASR 9000 Series Specifications

General

Series	ASR 9000
Category	Network Router
Modular Design	Yes
Redundancy	Yes (Hardware and Software)
Operating System	Cisco IOS XR
Interfaces/Ports	10G, 40G, 100G, 400G Ethernet
Expansion Slots	Varies by model
Routing Protocol	BGP, OSPF, IS-IS, EIGRP
Management	CLI, SNMP, NETCONF
Power Supply	Redundant
Port Density	Varies by model
Power Supply Options	AC, DC
Memory	Varies by model
Storage	Varies by model
Dimensions	Varies by model
Weight	Varies by model