Cisco ASR 9000 Series Configuration Guide

DETAILED STEPS
SUMMARY STEPS
1.
configure
2.
interface Bundle-Ether | Bundle-POS] bundle-id
3.
bfd address-family ipv4 minimum-interval milliseconds
4.
bfd address-family ipv4 multiplier multiplier
5.
commit
DETAILED STEPS
PurposeCommand or Action
configure
Step 1
Enters interface configuration mode for the specified
bundle ID.
interface Bundle-Ether | Bundle-POS] bundle-id
Example:
RP/0/RSP0/CPU0:router(config)# interface Bundle-Ether
1
Step 2
bfd address-family ipv4 minimum-interval milliseconds
Step 3
Example:
RP/0/RSP0/CPU0:router(config-if)#bfd address-family
ipv4 minimum-interval 2000
Note
•
Specifies the minimum interval, in milliseconds,
for asynchronous mode control packets on IPv4
BFD sessions on bundle member links. The range
is from 15 to 30000.Although the command allows
you to configure a minimum of 15 ms, the
supported minium on the
Cisco ASR 9000 Series Router is 50 ms.
Specifies a number that is used as a multiplier with
the minimum interval to determine BFD control and
bfd address-family ipv4 multiplier multiplier
Example:
RP/0/RSP0/CPU0:router(config-if)#bfd address-family
ipv4 multiplier 30
Step 4
echo packet failure detection times and echo packet
transmission intervals for IPv4 BFD sessions on
bundle member links. The range is from 2 to 50. The
default is 3.
Note
•
Although the command allows you
to configure a minimum of 2, the
supported minimum is 3.
commit
Step 5
Cisco ASR 9000 Series Aggregation Services Router Routing Configuration Guide, Release 5.1.x
OL-30423-03 207
Implementing BFD
Configuring BFD on Bundle Member Links

Cisco ASR 9000 Series Specifications

General

Brand	Cisco
Model	ASR 9000 Series
Category	Network Router
Language	English