To Next PageTo Next PageWhat to do if my Cisco ASR-920-12SZ-IM shows a red light due to fan failures and critical error?
If your Cisco Network Router is showing a red light due to single or multiple fan failures and a critical error, this indicates a problem with the device's cooling system. Ensure that the fans are free from obstructions and are functioning correctly. If the issue persists, it indicates a serious hardware problem.
Why my Cisco ASR-920-12SZ-IM has no power input?
If your Cisco Network Router has no valid power input, the device will be off. Ensure the power cord is correctly connected to both the router and a working power outlet. Verify the power outlet is functioning correctly by testing it with another device.
Why is the light on my Cisco Network Router yellow, indicating low input voltage?
If the input voltage to your Cisco Network Router is low, the device will show a yellow light. Check the power source and ensure it meets the router's voltage requirements. A stable and correct voltage supply is necessary for proper operation.
General| DSL WAN | No |
|---|---|
| Ethernet WAN | Yes |
| Networking standards | IEEE 802.3x |
| Ethernet LAN data rates | 10, 100, 1000, 10000 Mbit/s |
| USB ports quantity | 2 |
| Ethernet LAN (RJ-45) ports | 8 |
| Product color | Gray |
| Rack capacity | 1U |
| Antenna type | Not supported |
| AC input voltage | 100 - 240 V |
| Power source type | AC, DC, PoE |
| AC input frequency | 50 - 60 Hz |
| Power consumption (typical) | 130 W |
| Non-operating altitude | 0 - 4570 m |
| Operating temperature (T-T) | -40 - 70 °C |
| Operating relative humidity (H-H) | 5 - 95 % |
| Safety | UL 60950-1, 2005, CAN/CSA C22.2 No. 60950-1: 2005, IEC 60950-1, 2005, EN 60950-1, 2005, AS/NZS 60950.1:2005 |
| Electromagnetic compatibility | FCC CFR47 Part 15 Class A |
| Mean time between failures (MTBF) | 407230 h |
| Firewall | - |
| Security algorithms | IPSec |
Weight and Dimensions| Depth | 286.54 mm |
|---|---|
| Width | 444.5 mm |
| Height | 44 mm |
| Weight | 4830 g |
