Example:
--- System Configuration Dialog ---
Would you like to enter the initial configuration dialog? [yes/no]: no
Step 2
Press Return to enter the user EXEC mode.
The following prompt is displayed:
Example:
Router>
Step 3
From the user EXEC mode, enter the enable command, as shown in the following example:
Example:
Router> enable
Step 4
At the password prompt, enter your system password, as shown in the following example. If an enable password has not
been set on your system, you can skip this step.
Example:
Password: enablepass
When your password is accepted, the privileged EXEC mode prompt is displayed:
Example:
Router#
You now have access to the CLI in the privileged EXEC mode. You can enter the necessary commands to complete the
required tasks.
Step 5
To exit the console session, enter the quit command, as shown in the following example:
Example:
Router# quit
Configuring Global Parameters
When you first start the setup program, configure the global parameters. These parameters are used for
controlling system-wide settings. Perform the following steps to enter the global parameters:
SUMMARY STEPS
1.
Connect a console terminal to the console port, and then boot the router. For more information on connecting
a console terminal, see Connecting Console Cables section.
2.
The first sections of the configuration script appear only at an initial system startup. On subsequent uses
of the setup facility, the script begins with a System Configuration Dialog as shown below: When you are
prompted about whether you want to enter the initial configuration dialog, enter yes.
Cisco ASR-920-12SZ-IM Aggregation Services Router Hardware Installation Guide
96
Initial Configuration
Configuring Global Parameters
To Next Page
Loading...
Need help?
General
Weight and Dimensions
