Cisco ASR-920-12SZ-IM - Installing the AC Power Cables

Installing the AC Power Cables
To install the AC power cables in the power supply slots:
SUMMARY STEPS
1.
Plug the power supply cord in the power supply module.
2.
Insert the power supply cord into the tie [1] and tighten the tie around the power supply cord as shown in
[2] in the figure below.
DETAILED STEPS
Step 1
Plug the power supply cord in the power supply module.
Step 2
Insert the power supply cord into the tie [1] and tighten the tie around the power supply cord as shown in [2] in the figure
below.
Figure 29: Attaching the AC Power Tie-and-Clip Cord
Cisco ASR-920-12SZ-IM Aggregation Services Router Hardware Installation Guide
76
Installing the Cisco ASR 920 Series Router
Installing the AC Power Supply Module