Connecting a Cable to the Input 10-Mhz or 1-PPS Interface
SUMMARY STEPS
1.
Connect one end of a shielded mini-coax cable to the GPS unit.
2.
Connect the other end of the shielded mini-coax cable to the 10-Mhz or 1-PPS port on the Cisco ASR 920
Series Router.
DETAILED STEPS
Step 1
Connect one end of a shielded mini-coax cable to the GPS unit.
Step 2
Connect the other end of the shielded mini-coax cable to the 10-Mhz or 1-PPS port on the Cisco ASR 920 Series Router.
Connecting a Cable to the Output 10-Mhz or 1-PPS Interface
SUMMARY STEPS
1.
Connect one end of a shielded mini-coax cable to the Slave unit.
2.
Connect the other end of the shielded mini-coax cable to the 10-Mhz or 1-PPS port on the Cisco ASR 920
Series Router.
DETAILED STEPS
Step 1
Connect one end of a shielded mini-coax cable to the Slave unit.
Step 2
Connect the other end of the shielded mini-coax cable to the 10-Mhz or 1-PPS port on the Cisco ASR 920 Series Router.
Connecting a Cable to the ToD Interface
SUMMARY STEPS
1.
Connect one end of a straight-through Ethernet cable to the GPS unit.
2.
Connect the other end of the straight-through Ethernet cable to the ToD or 1-PPS port on the Cisco ASR
920 Series Router.
Cisco ASR-920-12SZ-IM Aggregation Services Router Hardware Installation Guide
89
Installing the Cisco ASR 920 Series Router
Connecting Timing Cables
To Next Page
Loading...
