Cisco ASR-920-12SZ-IM Hardware Installation Guide

SUMMARY STEPS
1.
Ensure that the system (earth) ground connection has been made.
2.
If necessary, remove the blank power supply filler plate from the chassis power supply bay opening by
loosening the captive installation screws.
3.
Grasp the power supply handle with one hand. Place your other hand underneath the power supply. Slide
the power supply into the power supply bay. Make sure that the power supply is fully seated in the bay.
See the following figure.
4.
Slide the AC power supply cord inside the tie of the tie-and-holder and tighten the tie around the power
supply cord.
5.
Plug the power supply cord into the AC power supply.
Cisco ASR-920-12SZ-IM Aggregation Services Router Hardware Installation Guide
74
Installing the Cisco ASR 920 Series Router
Installing the AC Power Supply Module

Cisco ASR-920-12SZ-IM Specifications

General

DSL WAN	No
Ethernet WAN	Yes
Networking standards	IEEE 802.3x
Ethernet LAN data rates	10, 100, 1000, 10000 Mbit/s
USB ports quantity	2
Ethernet LAN (RJ-45) ports	8
Product color	Gray
Rack capacity	1U
Antenna type	Not supported
AC input voltage	100 - 240 V
Power source type	AC, DC, PoE
AC input frequency	50 - 60 Hz
Power consumption (typical)	130 W
Non-operating altitude	0 - 4570 m
Operating temperature (T-T)	-40 - 70 °C
Operating relative humidity (H-H)	5 - 95 %
Safety	UL 60950-1, 2005, CAN/CSA C22.2 No. 60950-1: 2005, IEC 60950-1, 2005, EN 60950-1, 2005, AS/NZS 60950.1:2005
Electromagnetic compatibility	FCC CFR47 Part 15 Class A
Mean time between failures (MTBF)	407230 h
Firewall	-
Security algorithms	IPSec

Weight and Dimensions

Depth	286.54 mm
Width	444.5 mm
Height	44 mm
Weight	4830 g