Cisco CATALYST 2960 - Monitoring Features; Switched Port Analyzer (SPAN) and Remote SPAN (RSPAN) for traffic monitoring on any port or VLAN; Four groups (history, statistics, alarms, and events) of embedded RMON agents for network monitoring and traffic analysis

3-10
Catalyst 2960 Switch Hardware Installation Guide
OL-7075-09
Chapter 3 Switch Installation (8-Port Switches)
Installing the Switch
Figure 3-4 Mounting the Switch Under a Desk or Shelf
After the switch is mounted under the desk or shelf, do these tasks to complete the installation:
1. Power on the switch. See the “Verifying Switch Operation” section on page 3-5.
2. Connect to a 10/100 or 10/100/1000 port, and run Express Setup. See the switch getting started guide
for instructions.
3. Connect to the front-panel ports. See the “Connecting to the 10/100 and 10/100/1000 Ports” section
on page 2-14, the “Connecting to SFP Modules” section on page 2-18, and the “Connecting to a
Dual-Purpose Port” section on page 2-20 to complete the installation.
For configuration instructions about using the CLI setup program, go to Appendix C, “Configuring the
Switch with the CLI-Based Setup Program.”
1 Desk or shelf 3 Slides on this way
2 Screws
Catalyst 2960
S
eries
STAT
DPLX
SPD
SYST
CONSOLE
3
1x 2x 3x 4x
5x
6x 7x 8x
1
1
2
204640