Cisco Catalyst 3120

Contents
xxxii
Cisco Catalyst Blade Switch 3120 for HP Software Configuration Guide
OL-12247-01
Configuring Static Unicast Routes 38-83
Specifying Default Routes and Networks 38-84
Using Route Maps to Redistribute Routing Information 38-85
Configuring Policy-Based Routing 38-88
PBR Configuration Guidelines 38-89
Enabling PBR 38-90
Filtering Routing Information 38-92
Setting Passive Interfaces 38-92
Controlling Advertising and Processing in Routing Updates 38-93
Filtering Sources of Routing Information 38-93
Managing Authentication Keys 38-94
Monitoring and Maintaining the IP Network 38-95
CHAPTER 39 Configuring IPv6 Unicast Routing 39-1
Understanding IPv6 39-1
IPv6 Addresses 39-2
Supported IPv6 Unicast Routing Features 39-3
128-Bit Wide Unicast Addresses 39-3
DNS for IPv6 39-4
Path MTU Discovery for IPv6 Unicast 39-4
ICMPv6 39-4
Neighbor Discovery 39-4
IPv6 Applications 39-5
Dual IPv4 and IPv6 Protocol Stacks 39-5
EIGRP IPv6 39-6
Unsupported IPv6 Unicast Routing Features 39-9
Limitations 39-9
IPv6 and Switch Stacks 39-10
SDM Templates 39-11
Dual IPv4-and IPv6 SDM Templates 39-11
Configuring IPv6 39-12
Default IPv6 Configuration 39-13
Configuring IPv6 Addressing and Enabling IPv6 Routing 39-13
Configuring IPv4 and IPv6 Protocol Stacks 39-15
Configuring IPv6 ICMP Rate Limiting 39-17
Configuring CEF and dCEF for IPv6 39-17
Configuring Static Routing for IPv6 39-18
Configuring RIP for IPv6 39-20
Configuring OSPF for IPv6 39-22