2-2
Catalyst 6500 Series Switch SIP, SSC, and SPA Hardware Installation Guide
OL-9041-04
Chapter 2 Catalyst 6500 Series Switch SIPs and SSCs Overview
Identifying Slots and Subslots for SIPs, SSCs, and SPAs
Checking For Hardware and Software Compatibility
To check the minimum software requirements of Cisco IOS software with the hardware installed on your
router, Cisco maintains the Software Advisor tool on Cisco.com. This tool does not verify whether SIPs
or SPAs within a system are compatible, but it does provide the minimum Cisco IOS requirements for
individual hardware modules or components.
Note Access to this tool is limited to users with Cisco.com login accounts.
To access Software Advisor, click Login at Cisco.com, type “Software Advisor” in the SEARCH box,
and click GO. Click the link for the Software Advisor tool.
Choose a product family or enter a specific product number to search for the minimum supported
software release needed for your hardware.
Identifying Slots and Subslots for SIPs, SSCs, and SPAs
This section describes how to specify the physical location of a SIP, SSC, or SPA on the Catalyst 6500
Series switch using the command-line interface (CLI) to configure or monitor those devices.
Note For simplicity, any reference to “SIP” in this section also applies to the SSC.
Specifying the Slot Location for a SIP or SSC
The Catalyst 6500 Series switch supports different chassis models, each of which supports a certain
number of chassis slots.
Note The Catalyst 6500 Series switch SIPs are not supported with a Supervisor Engine 1, Supervisor
Engine 1A, Supervisor Engine 2, or Supervisor Engine 720-3A.
To Next Page
Loading...
Need help?
General