3-7
Catalyst 6500 Series Content Switching Module Configuration Note
OL-4612-01
Chapter 3 Getting Started
Configuring SLB Modes
Changing Modes
You can change the CSM operating mode from CSM mode to RP mode or RP mode to CSM mode. The
next sections provide examples of how to change the modes.
CSM Mode to RP Mode
This example shows how to change from CSM mode to RP mode. This example is typical of a migration
from CSM 1.x to 2.1 or later releases and does not require a module reset.
Cat6k# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Cat6k(config)# ip slb mode ?
csm SLB in Content Switching Module
rp SLB in IOS system
Cat6k(config)# ip slb mode rp
% The current SLB mode is CSM-SLB.
% You are selecting RP-SLB mode.
% All configuration for CSM-SLB will be moved to module submode.
% Confirm switch to RP-SLB mode? [no]: yes
% Enter slot number for CSM module configuration, 0 for none [5]: 5
% Please save the configuration.
Cat6k(config)# end
Cat6k# write
Building configuration...
[OK]
Cat6k#
RP Mode to CSM Mode
This example shows how to migrate from RP mode to CSM mode and requires a module reset:
Cat6k# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Cat6k(config)# ip slb mode ?
csm SLB in Content Switching Module
rp SLB in IOS system
Cat6k(config)# ip slb mode csm
% The current SLB mode is RP-SLB.
% You are selecting CSM-SLB.
% All SLB configurations for RP will be ERASED.
% After execution of this command, you must
% write the configuration to memory and reload.
% CSM-SLB module configuration will be moved to ip slb submodes.
% Confirm switch to CSM-SLB mode? [no]: yes
% Enter slot number for CSM module configuration, 0 for none [5]: 5
% Please save the configuration and reload.
Cat6k(config)# end
Cat6k# write
Building configuration...
Cat6k# reload
Proceed with reload? [confirm] y
Verify Mode Operation
To Next Page
Loading...
Need help?
General