Cisco Catalyst 6500 Series Configuration Note

3-8
Catalyst 6500 Series Content Switching Module Configuration Note
OL-4612-01
Chapter 3 Getting Started
Configuring SLB Modes
Verifying the Configuration
To confirm that your configuration is working properly, use these commands in the RP mode:
Cat6k# show ip slb mode
SLB configured mode = rp
Cat6k# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Catk6-1(config)# ip slb ?
dfp configure Dynamic Feedback Protocol manager
entries initial and maximum SLB entries
firewallfarm configure an SLB firewall farm
mode configure SLB system mode
natpool define client nat pool
probe configure an SLB probe
serverfarm configure an SLB server farm
vserver configure an SLB virtual server
To confirm that you configuration is working properly, use these commands in the Cisco IOS SLB mode:
Cat6k(config)# module csm 5
Cat6k(config-module-csm)# ?
SLB CSM module config
default Set a command to its defaults
dfp configure Dynamic Feedback Protocol manager
exit exit SLB CSM module submode
ft configure CSM fault tolerance (ft) feature
map configure an SLB map
natpool configure client nat pool
no Negate a command or set its defaults
policy configure an SLB policy
probe configure an SLB probe
serverfarm configure an SLB server farm
static configure static NAT for server initiated connections
sticky configure a sticky group
vlan configure a vlan
vserver configure an SLB virtual server
To confirm that a single CSM in the chassis configuration is working properly, use these commands in
the CSM mode:
Cat6k# show ip slb mode
SLB configured mode = csm
Catk6-1# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Cat6k(config)# ip slb ?
dfp configure Dynamic Feedback Protocol manager
ft configure CSM fault tolerance (ft) feature
map configure an SLB map
mode configure SLB system mode
natpool configure client nat pool
policy configure an SLB policy
probe configure an SLB probe
serverfarm configure an SLB server farm
static configure static NAT for server initiated connections
sticky configure a sticky group
vlan configure a vlan
vserver configure an SLB virtual server

Cisco Catalyst 6500 Series Specifications

General

Brand	Cisco
Model	Catalyst 6500 Series
Category	Switch
Language	English