Cisco Catalyst 6500 Series Configuration Note

B-1
Catalyst 6500 Series Content Switching Module Configuration Note
OL-4612-01
APPENDIX B
Troubleshooting and System Messages
This appendix describes how to troubleshoot the CSM and system messages you may receive.
Troubleshooting
When a CSM is out-of-service the module still replies to ARP requests but will not reply to pings.
System Messages
This section lists system log (syslog) messages supported in the CSM.
For the Cisco IOS, the message logs contain the warning level with this syntax:
CSM_SLB_ level-code
Table B-1 lists he level codes:
Error Message CSM_SLB-3-IDB_ERROR Unknown error occurred while configuring IDB
Explanation
The MFSC could not create the internal interfaces for the CSM.
Recommended Action Either this version of the MFSC or the IDPROM were incorrectly programmed.
Reprogram the MFSC or the IDPROM.
Table B-1 Error Message Level Codes
Message Level Code
LOG_EMERG 0 /* system is unusable */
LOG_ALERT 1 /* action must be taken immediately */
LOG_CRIT 2 /* critical conditions */
LOG_ERR 3 /* error conditions */
LOG_WARNING 4 /* warning conditions */
LOG_NOTICE 5 /* normal but signification condition */
LOG_INFO 6 /* informational */
LOG_DEBUG 7 /* debug-level messages */

Cisco Catalyst 6500 Series Specifications

General

Brand	Cisco
Model	Catalyst 6500 Series
Category	Switch
Language	English