splice fiber pigtail of optical fiber input cable to your splice
enclosure and continue to Fiber Optic Connections - Active to
Passive Modules (on page 33).
2 Select a left side (ports TP1 or TP2) or a right side (ports TP4 or TP5) fiber
connection port for use and remove its sealing plug.
3 Slip a length of heat shrink tubing over the MPO fiber cable connectors and past
the main body nut. Use a piece long enough to cover the cable connector and
fiber port nut when assembled later.
4 One at a time, carefully insert the MPO fiber cable connectors through the fiber
connection port and into the hub housing. Do not bend or kink fibers.
To Next Page
Loading...
