Note: It may take a few attempts to determine the correct length of fiber to
reach each passive module. It's best to not insert the fibers in the routing tracks
while estimating the proper length. Rather, position the fibers on top of the
tracks while estimating.
6 Route each fiber to its intended passive module through the fiber track on the
fiber slack spool and then through the passive device fiber routing track as
necessary.
7 Before connection, carefully clean the optical connectors on both fiber and
module according to the procedures in Care and Cleaning of Optical Connectors
(on page 103).
8 Open the various module fiber connector covers. Carefully slide the fiber
connectors into the module connectors until they click.
9 Continue to RF Cable Installation (on page 37).
To Next Page
Loading...
Need help?
General
