Cisco Nexus 5000 Series - Configuring SAN Port Channels

particular exchange are sent on the same link. For exchange 1, no frame uses link 2. For the next exchange,
link 2 is chosen by the hash algorithm. Now all frames in exchange 2 use link 2.
Figure 23: SID1, DID1, and Exchange-Based Load Balancing
Configuring SAN Port Channels
SAN port channels are created with default values. You can change the default configuration just as any other
physical interface.
Cisco Nexus 5000 Series NX-OS SAN Switching Configuration Guide, Release 5.2(1)N1(1)
OL-27583-01 99
Configuring SAN Port Channels
Configuring SAN Port Channels