Cisco Nexus 5000 Series - Port Security Configuration Distribution; Enabling Port Security Distribution

This example shows how to configure the specified pWWN to log in through the specified interface in the
specified switch:
switch(config-port-security)# pwwn 20:11:33:11:00:2a:4a:66 swwn 20:00:00:0c:85:90:3e:80
interface vfc 32
This example shows how to configure any WWN to log in through the specified interface in any switch:
switch(config-port-security)# any-wwn interface vfc 32
Port Security Configuration Distribution
The port security feature uses the Cisco Fabric Services (CFS) infrastructure to enable efficient database
management, provide a single point of configuration for the entire fabric in the VSAN, and enforce the port
security policies throughout the fabric.
For additional information, refer to Using Cisco Fabric Services in the System Management Configuration
Guide for your device.
Enabling Port Security Distribution
You can enable port security distribution.
SUMMARY STEPS
1.
configure terminal
2.
port-security distribute
3.
no port-security distribute
DETAILED STEPS
PurposeCommand or Action
Enters global configuration mode.configure terminal
Example:
switch# configure terminal
switch(config)#
Step 1
Enables distribution.port-security distribute
Example:
switch(config)# port-security distribute
Step 2
Disables distribution.no port-security distribute
Example:
switch(config)# no port-security distribute
Step 3
Related Topics
Activation and Auto-Learning Configuration Distribution, on page 268
Cisco Nexus 5000 Series NX-OS SAN Switching Configuration Guide, Release 5.2(1)N1(1)
266 OL-27583-01
Configuring Port Security
Port Security Configuration Distribution