The pending database is only available in the volatile directory and are subject to being discarded if the switch
is restarted.
To use administrative privileges and release a locked DPVM session, use the clear rscn session vsan command
in EXEC mode. This example shows how to clear the RSCN session for VSAN 10:
switch# clear rscn session vsan 10
Displaying RSCN Configuration Distribution Information
This example shows how to display the registration status for RSCN configuration distribution:
switch# show cfs application name rscn
Enabled : Yes
Timeout : 5s
Merge Capable : Yes
Scope : Logical
A merge failure results when the RSCN timer values are different on the merging fabrics.Note
This example shows how to display the set of configuration commands that would take effect when you
commit the configuration:
The pending database includes both existing and modified configuration.Note
switch# show rscn pending
rscn event-tov 2000 ms vsan 1
rscn event-tov 2000 ms vsan 2
rscn event-tov 300 ms vsan 10
This example shows how to display the difference between pending and active configurations:
switch# show rscn pending-diff vsan 10
- rscn event-tov 2000 ms vsan 10
+ rscn event-tov 300 ms vsan 10
Default Settings for RSCN
The following table lists the default settings for RSCN.
Table 27: Default RSCN Settings
DefaultParameters
2000 milliseconds for Fibre Channel VSANsRSCN timer value
DisabledRSCN timer configuration distribution
Cisco Nexus 5000 Series NX-OS SAN Switching Configuration Guide, Release 5.2(1)N1(1)
OL-27583-01 213
Managing FLOGI, Name Server, FDMI, and RSCN Databases
Default Settings for RSCN
To Next Page
Loading...
