Cisco Nexus 5000 Series - Configuring Retransmitting Intervals; About Disabling FSPF for Specific Interfaces; Disabling FSPF for Specific Interfaces

This value must be the same on the switches on both ends of the interface.Note
Configuring Retransmitting Intervals
You can configure the FSPF retransmit time interval.
SUMMARY STEPS
1.
configure terminal
2.
switch(config)# interface fc slot/port
3.
fspf retransmit-interval value vsan vsan-id
DETAILED STEPS
PurposeCommand or Action
Enters global configuration mode.configure terminal
Example:
switch# configure terminal
switch(config)#
Step 1
Configures the specified interface, or if already configured,
enters configuration mode for the specified interface.
switch(config)# interface fc slot/port
Step 2
Specifies the retransmit time interval for unacknowledged
link state updates in the specified VSAN. The default is 5
seconds.
fspf retransmit-interval value vsan vsan-id
Example:
switch(config-if)# fspf retransmit-interval
10 vsan 25
Step 3
About Disabling FSPF for Specific Interfaces
You can disable the FSPF protocol for selected interfaces. By default, FSPF is enabled on all E ports and TE
ports. This default can be disabled by setting the interface as passive.
FSPF must be enabled at both ends of the interface for the protocol to work.Note
Disabling FSPF for Specific Interfaces
You can disable the FSPF protocol for selected interfaces. By default, FSPF is enabled on all E ports and TE
ports. This default can be disabled by setting the interface as passive.
Cisco Nexus 5000 Series NX-OS SAN Switching Configuration Guide, Release 5.2(1)N1(1)
188 OL-27583-01
Configuring Fibre Channel Routing Services and Protocols
FSPF Interface Configuration