Cisco Nexus 5000 Series - Displaying the In-Order Delivery Status; Configuring the Drop Latency Time

Displaying the In-Order Delivery Status
Use the show in-order-guarantee command to display the present configuration status:
switch# show in-order-guarantee
global inorder delivery configuration:guaranteed
VSAN specific settings
vsan 1 inorder delivery:guaranteed
vsan 101 inorder delivery:not guaranteed
vsan 1000 inorder delivery:guaranteed
vsan 1001 inorder delivery:guaranteed
vsan 1682 inorder delivery:guaranteed
vsan 2001 inorder delivery:guaranteed
vsan 2009 inorder delivery:guaranteed
vsan 2456 inorder delivery:guaranteed
vsan 3277 inorder delivery:guaranteed
vsan 3451 inorder delivery:guaranteed
vsan 3452 inorder delivery:guaranteed
Configuring the Drop Latency Time
You can change the default latency time for a network, a specified VSAN in a network, or for the entire switch.
SUMMARY STEPS
1.
configure terminal
2.
fcdroplatency network value
3.
fcdroplatency network value vsan vsan-id
4.
no fcdroplatency network value
DETAILED STEPS
PurposeCommand or Action
Enters global configuration mode.configure terminal
Example:
switch# configure terminal
switch(config)#
Step 1
Configures network drop latency time for the network. The
valid range is from 0 to 60000 msec. The default is 2000 msec.
fcdroplatency network value
Example:
switch(config)# fcdroplatency network 1000
Step 2
The network drop latency must be computed as the
sum of all switch latencies of the longest path in the
network.
Note
Configures network drop latency time for the specified VSAN.
fcdroplatency network value vsan vsan-id
Example:
switch(config)# fcdroplatency network 1000
vsan 12
Step 3
Cisco Nexus 5000 Series NX-OS SAN Switching Configuration Guide, Release 5.2(1)N1(1)
OL-27583-01 195
Configuring Fibre Channel Routing Services and Protocols
In-Order Delivery