Cisco Nexus 5000 Series - Resetting FSPF to the Default Configuration

DETAILED STEPS
PurposeCommand or Action
Enters global configuration mode.configure terminal
Example:
switch# configure terminal
switch(config)#
Step 1
Enters FSPF global configuration mode for the specified VSAN.
fspf config vsan vsan-id
Step 2
Example:
switch(config)# fspf config vsan 14
User needs to configure the VSAN on which FSPF is
being configured.
Note
Forces static SPF computation for the dynamic (default)
incremental VSAN.
spf static
Example:
switch-config-(fspf-config)# spf static
Step 3
Configures the hold time between two route computations in
milliseconds (msec) for the entire VSAN. The default value is 0.
spf hold-time value
Example:
switch-config-(fspf-config)# spf hold-time
10
Step 4
If the specified time is shorter, the routing is faster.
However, the processor consumption increases
accordingly.
Note
Configures the autonomous region for this VSAN and specifies
the region ID.
region region-id
Example:
switch-config-(fspf-config)# region 1
Step 5
Resetting FSPF to the Default Configuration
You can return the FSPF VSAN global configuration to its factory default.
SUMMARY STEPS
1.
configure terminal
2.
no fspf config vsan vsan-id
DETAILED STEPS
PurposeCommand or Action
Enters global configuration mode.configure terminal
Example:
switch# configure terminal
switch(config)#
Step 1
Cisco Nexus 5000 Series NX-OS SAN Switching Configuration Guide, Release 5.2(1)N1(1)
OL-27583-01 183
Configuring Fibre Channel Routing Services and Protocols
FSPF Global Configuration