PurposeCommand or Action
Verifying Interoperating Status
This section highlights the commands used to verify if the fabric is up and running in interoperability mode.
To verify the resulting status of entering the interoperability command in any Cisco Nexus device, perform
this task:
SUMMARY STEPS
1.
Verify the software version.
2.
Verify if the interface states are as required by your configuration.
3.
Verify if you are running the desired configuration.
4.
Verify if the interoperability mode is active.
5.
Verify the domain ID.
6.
Verify the local principal switch status.
7.
Verify the next hop and destination for the switch.
8.
Verify the name server information.
DETAILED STEPS
Step 1
Verify the software version.
Example:
switch# show version
Cisco Nexus Operating System (NX-OS) Software
TAC support: http://www.cisco.com/tac
Copyright (c) 2002-2008, Cisco Systems, Inc. All rights reserved.
The copyrights to certain works contained herein are owned by
other third parties and are used and distributed under license.
Some parts of this software are covered under the GNU Public
License. A copy of the license is available at
http://www.gnu.org/licenses/gpl.html.
Cisco Nexus 5000 Series NX-OS SAN Switching Configuration Guide, Release 5.2(1)N1(1)
232 OL-27583-01
Advanced Fibre Channel Features
Switch Interoperability
To Next Page
Loading...
