Cisco Nexus 5000 Series - Analyzing the Zone and Zone Set; Default Settings for Zones

SUMMARY STEPS
1.
configure terminal
2.
no zone name zone-name vsan vsan-id
3.
zone compact vsan vsan-id
DETAILED STEPS
PurposeCommand or Action
Enters global configuration mode.configure terminal
Example:
switch# configure terminal
switch(config)#
Step 1
Deletes a zone to reduce the number of zones to 2000
or fewer.
no zone name zone-name vsan vsan-id
Example:
switch(config)# no zone name myzone vsan 35
Step 2
Compacts the zone database for the specified VSAN to
recover the zone ID released when a zone was deleted.
zone compact vsan vsan-id
Example:
switch(config)# zone compact vsan 42
Step 3
Analyzing the Zone and Zone Set
To better manage the zones and zone sets on your switch, you can display zone and zone set information using
the show zone analysis command.
The following example shows how to display full zoning analysis:
switch# show zone analysis vsan 1
The following example shows how to display active zoning analysis:
switch# show zone analysis active vsan 1
See the command reference for your device for the description of the information displayed in the command
output.
Default Settings for Zones
The following table lists the default settings for basic zone parameters.
Table 22: Default Basic Zone Parameters
DefaultParameters
Denied to all members.Default zone policy
Cisco Nexus 5000 Series NX-OS SAN Switching Configuration Guide, Release 5.2(1)N1(1)
164 OL-27583-01
Configuring and Managing Zones
Analyzing the Zone and Zone Set