Cisco Nexus 5000 Series - Hello Time Intervals; Configuring Hello Time Intervals

PurposeCommand or Action
Configures the cost for the selected interface in the specified
VSAN.
fspf cost value vsan vsan-id
Example:
switch(config-if)# fspf cost 500 vsan 38
Step 3
Hello Time Intervals
You can set the FSPF Hello time interval to specify the interval between the periodic hello messages that are
sent to verify the health of the link. The integer value can range from 1 to 65,535 seconds.
This value must be the same in the ports at both ends of the ISL.Note
Configuring Hello Time Intervals
You can configure the FSPF Hello time interval.
SUMMARY STEPS
1.
configure terminal
2.
switch(config)# interface fc slot/port
3.
fspf hello-interval value vsan vsan-id
DETAILED STEPS
PurposeCommand or Action
Enters global configuration mode.configure terminal
Example:
switch# configure terminal
switch(config)#
Step 1
Configures the specified interface, or if already configured,
enters configuration mode for the specified interface.
switch(config)# interface fc slot/port
Step 2
Specifies the hello message interval to verify the health of
the link in the VSAN. The default is 20 seconds.
fspf hello-interval value vsan vsan-id
Example:
switch(config-if)# fspf hello-interval 25 vsan
10
Step 3
Cisco Nexus 5000 Series NX-OS SAN Switching Configuration Guide, Release 5.2(1)N1(1)
186 OL-27583-01
Configuring Fibre Channel Routing Services and Protocols
FSPF Interface Configuration