Cisco Nexus 5000 Series - Configuring Global Attributes for Fibre Channel Interfaces; Configuring Switch Port Attribute Default Values

SUMMARY STEPS
1.
switch# configuration terminal
2.
switch(config)# interface fc slot/port
3.
switch(config-if)# switchport ignore bit-errors
4.
switch(config-if)# no switchport ignore bit-errors
DETAILED STEPS
PurposeCommand or Action
Enters configuration mode.switch# configuration terminal
Step 1
Selects a Fibre Channel interface and enters interface
configuration mode.
switch(config)# interface fc slot/port
Step 2
Prevents the detection of bit error threshold events from
disabling the interface.
switch(config-if)# switchport ignore bit-errors
Step 3
Prevents the detection of bit error threshold events from
enabling the interface.
switch(config-if)# no switchport ignore bit-errors
Step 4
Configuring Global Attributes for Fibre Channel Interfaces
Configuring Switch Port Attribute Default Values
You can configure attribute default values for various switch port attributes. These attributes will be applied
globally to all future switch port configurations, even if you do not individually specify them at that time.
To configure switch port attributes, perform this task:
SUMMARY STEPS
1.
switch# configuration terminal
2.
switch(config)# no system default switchport shutdown san
3.
switch(config)# system default switchport shutdown san
4.
switch(config)# system default switchport trunk mode auto
DETAILED STEPS
PurposeCommand or Action
Enters configuration mode.switch# configuration terminal
Step 1
Cisco Nexus 5000 Series NX-OS SAN Switching Configuration Guide, Release 5.2(1)N1(1)
OL-27583-01 23
Configuring Fibre Channel Interfaces
Configuring Global Attributes for Fibre Channel Interfaces