EasyManuals Logo

Cisco RV180W Administration Guide

Cisco RV180W
187 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #141 background imageLoading...
Page #141 background image
Configuring Quality of Service (QoS)
Configuring WAN QoS Profiles
Cisco RV180/RV180W Administration Guide 132
6
STEP 3 When prompted to reset the previous priority or rate limit configuration, click OK.
STEP 4 Click Save.
Configuring Bandwidth Allocation Settings
To configure the WAN QoS bandwidth allocation settings:
STEP 1 Choose QoS > WAN QoS Profiles.
STEP 2 Under Priority Bandwidth Allocation Settings:
If the WAN QoS mode is set to Priority, enter this information:
Each one of these values specifies the percentage of the total bandwidth
(100 Mbps) allocated to these priority levels.
If the WAN QoS mode is set to Rate Limit, enter this information:
STEP 3 Click Save.
Adding WAN QoS Profiles
To add a WAN QoS profile:
STEP 1 Choose QoS > WAN QoS Profiles.
STEP 2 In the WAN QoS Profile Table, click Add.
High Priority Enter a value between 61 (default) and 100.
Medium Priority Enter a value between 31 (default) and 60.
Low Priority Enter a value between 10 (default) and 30.
Total WAN (Internet)
Bandwidth
Enter the total WAN bandwidth (1100 Mbps).

Table of Contents

Other manuals for Cisco RV180W

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco RV180W and is the answer not in the manual?

Cisco RV180W Specifications

General IconGeneral
BrandCisco
ModelRV180W
CategoryNetwork Router
LanguageEnglish

Related product manuals