Cisco RV180W - Configuring Pppoe; Configuring PPTP

Configuring Networking
Configuring the WAN (Internet) Settings
Cisco RV180/RV180W Administration Guide 26
2
STEP 4 Enter MTU information. (See Configuring MTU Settings, page 28.)
STEP 5 Enter MAC Address information. (See Configuring the MAC Address, page 29.)
STEP 6 Click Save.
Configuring PPPoE
If you have a Point-to-Point Protocol over Ethernet (PPPoE) connection to the
Internet:
STEP 1 Choose Networking > WAN (Internet) > IPv4 WAN (Internet).
STEP 2 From the Internet Connection Type drop-down menu, choose PPPoE.
STEP 3 From the PPPoE Profile Name drop-down menu, choose a PPPoE profile. If no
profile is listed, click Configure Profile to create a new profile.
To see the details of available profiles, choose
Networking > WAN (Internet) > PPPoE Profiles. See Configuring PPPoE
Profiles, page 29 for more information.
STEP 4 Enter MTU information. (See Configuring MTU Settings, page 28.)
STEP 5 Enter MAC Address information. (See Configuring the MAC Address, page 29.)
STEP 6 Click Save.
Configuring PPTP
If you have a Point-to-Point Tunneling Protocol (PPTP) connection to the Internet:
STEP 1 Choose Networking > WAN (Internet) > IPv4 WAN (Internet).
STEP 2 From the Internet Connection Type drop-down menu, choose PPTP.
STEP 3 Enter this information:
User Name Enter your username assigned to you by the ISP.
Password Enter your password assigned to you by the ISP.