Viewing the Cisco RV180/RV180W Status
IPsec Connection Status
Cisco RV180/RV180W Administration Guide 167
8
NOTE The counters are reset when the device is restarted.
IPsec Connection Status
The IPsec Connection Status page displays the status of IPsec connections.
To view the status of IPsec connections:
STEP 1 Choose Status > IPsec Connection Status.
STEP 2 Click Stop.
STEP 3 In the Poll Interval field, enter the number of seconds the router waits before
updating the information on this page.
STEP 4 Click Start to restart automatic refresh at the specified poll interval.
You can change the status of a connection to either establish or disconnect the
configured SAs (Security Associations).
Errors The number of received/sent packet errors
reported to the radio, over all configured APs.
Dropped The number of received/sent packets dropped by
the radio, over all configured APs.
Multicast The number of multicast packets sent over this
radio.
Collisions The number of packet collisions reported to the AP.
Policy Name The name of the IKE or VPN policy associated with
this SA.
Endpoint Displays the IP address of the remote VPN
gateway or client.
Kbytes The data transmitted (in KB) over this SA.
Packets The number of IP packets transmitted over this SA.
To Next Page
Loading...
