Administering Your Cisco RV180/RV180W
Configuring the Discovery Settings
Cisco RV180/RV180W Administration Guide 149
7
STEP 5 Under Logging Policy, choose the type of logging policy. (See Configuring
Logging Policies, page 146.) By default, only IPsec VPN logs are enabled. Others
are disabled.
STEP 6 If you want the router to send logs to a Syslog server, check the box next to a
syslog server field and enter the IP address or Internet Name of the Syslog server
in the Syslog Server field. Choose the logging policy for each syslog server. You
can configure up to 8 syslog servers.
STEP 7 Click Save.
Configuring the Discovery Settings
The Cisco RV180/RV180W supports two types of discovery protocols: Bonjour
and Universal Plug and Play (UPnP).
Configuring Bonjour
Bonjour is a service advertisement and discovery protocol. To configure Bonjour:
STEP 1 Choose Administration > Discovery Settings > Discovery - Bonjour.
STEP 2 Check the Enable box to enable Bonjour on the router. Unchecking this will disable
Bonjour.
STEP 3 In the Bonjour Interface Control Table, you can see on which VLANs Bonjour is
enabled. For example, Bonjour is by default enabled on the default VLAN ID 1. That
means that the Cisco RV180/RV180W advertises itself to all devices connected to
it on VLAN 1, and devices joining the network can connect to the Cisco RV180/
RV180W. If you have other VLANs created on your network, you can enable
Bonjour on those VLANs too. (See Configuring Virtual LAN (VLAN) Membership,
page 34 for more information.)
STEP 4 Click Save.
To Next Page
Loading...
