Cisco SGE2000 User Manual

133
Chapter 7: Configuring IP Information
Configuring Layer 3
SGE2000/SGE2000P Gigabit Ethernet Switch Reference Guide
Chapter
7
ARP Proxy Page
The ARP Proxy Page contains the following field.
• ARP Proxy — Enables the device to respond to ARP requests for located nodes. If disabled, the
device responds with its own MAC address.
2. Enable ARP Proxy.
3. Click Apply. Arp Proxy is enabled, and the device is updated.
UDP Relay
The UDP Relay allows UDP packets to reach other networks. This feature enables browsing from
workstations to servers on different networks. The UDP Relay Page contains the following fields.
1. Click System > System Management > IP Addressing > UDP Relay. The UDP Relay Page opens:

Cisco SGE2000 Specifications

General

Jumbo Frame Support	9KB
VLANs	Up to 256
Management	Web-based, SNMP, CLI
Standards	IEEE 802.3, 802.3u, 802.3ab, 802.3z, 802.3x, 802.1D, 802.1Q, 802.1p, 802.1w
Dimensions	440 x 44 x 257 mm
Power Supply	100 to 240V AC, 50-60 Hz
Operating Temperature	0°C to 40°C
Storage Temperature	-20 to 70°C (-4 to 158°F)
Humidity	10% to 90% non-condensing
Weight	3.2 kg