137
Chapter 7: Configuring IP Information
Configuring Layer 3
SGE2000/SGE2000P Gigabit Ethernet Switch Reference Guide
Chapter
7
Add DHCP Server Page
The Add DHCP Server Page contains the following field:
• DHCP Server —Adds a DHCP Server to the DHCP Relay Table. The DHCP servers act as a DHCP
relay if the parameter is not equal to 0.0.0.0. DHCP requests are relayed only if their SEC field is
greater or equal to the threshold value. This allows local DHCP Servers to respond first.
3. Define the relevant field.
4. Click Apply. THe DHCP Server is added, and the device is updated.
ARP
The Address Resolution Protocol (ARP) is a TCP/IP protocol that converts IP addresses into physical
addresses. The ARP table is used to maintain a correlation between each MAC address and its
corresponding IP address. The ARP table can be filled in statically by the user. When a static ARP entry
is defined, a permanent entry is put in the table, which the system uses to translate IP addresses to MAC
addresses. To define ARP:
1. Click System > System Management > IP Addressing > ARP. The ARP Page opens:
To Next Page
Loading...
Need help?
General
