Cisco SGE2000

190
Chapter 11: Configuring SNMP
Defining Trap Management
SGE2000/SGE2000P Gigabit Ethernet Switch Reference Guide
Chapter
11
– Enable — Enables the device to send authentication failure notifications.
– Disable — Disables the device from sending authentication failure notifications.
Configuring Station Management
1. Click System > SNMP > Security > Trap Management > Station Management. The Station
Management Page opens:
Station Management Page
The Station Management Page contains two areas, the SNMPv1,2 Notification Recipient and the
SNMPv3 Notification Recipient table.
The SNMPv1,2 Notification Recipient table area contains the following fields:
• Recipients IP — Indicates the IP address to whom the traps are sent.
• Notification Type — Defines the notification sent. The possible field values are:
– Trap — Indicates traps are sent.
– Inform — Indicates informs are sent.
• Community String — Identifies the community string of the trap manager.
• Notification Version — Determines the trap type. The possible field values are:
– SNMP V1 — Indicates SNMP Version 1 traps are sent.