Cisco SGE2000

189
Chapter 11: Configuring SNMP
Defining Trap Management
SGE2000/SGE2000P Gigabit Ethernet Switch Reference Guide
Chapter
11
Defining Trap Management
The Defining Trap Management section contains the following pages:
• Defining Trap Settings
• Configuring Station Management
• Defining SNMP Filter Settings
Defining Trap Settings
1. Click System > SNMP > Security > Trap Management > Trap Settings. The Trap Settings Page
opens:
Trap Settings Page
The Trap Settings Page contains the following fields:
• Enable SNMP Notification — Specifies whether the device can send SNMP notifications. The
possible field values are:
– Enable — Enables SNMP notifications.
– Disable — Disables SNMP notifications.
• Enable Authentication Notification — Specifies whether SNMP authentication failure notification
is enabled on the device. The possible field values are: