Cisco SGE2000

204
Chapter 12: Configuring Quality of Service
Defining General Settings
SGE2000/SGE2000P Gigabit Ethernet Switch Reference Guide
Chapter
12
Mapping CoS to Queue
1. Click Quality of Service > General > CoS to Queue. The Cos to Queue Page opens:
Cos to Queue Page
The Cos to Queue Page contains the following fields:
• Restore Defaults — Restores all queues to the default CoS settings.
• Class of Service — Specifies the CoS VLAN (CoS) priority tag values, where zero is the lowest and
8 is the highest.
• Queue — Defines the traffic forwarding queue to which the CoS priority is mapped. Four traffic
priority queues are supported, where Queue 4 is the highest and Queue 1 is the lowest.
2. Define the relevant fields.
3. Click Apply. Cos to queues are mapped, and the device is updated.