Cisco SGE2000

144
Chapter 8: Defining Address Tables
Defining Static Addresses
SGE2000/SGE2000P Gigabit Ethernet Switch Reference Guide
Chapter
8
Defining Static Addresses
A static address can be assigned to a specific interface on this switch. Static addresses are bound to the
assigned interface and cannot be moved. When a static address is seen on another interface, the address
will be ignored and will not be written to the address table. To define static addresses:
1. Click Bridging > Address Tables > Static. The Static Page opens:
Static Page
The Static Page contains the following fields:
• VLAN ID — Displays the VLAN ID number to which the entry refers.
• MAC Address — Displays the MAC address to which the entry refers.
• Interface — Displays the interface to which the entry refers:
– Port — The specific port number to which the forwarding database parameters refer.
– LAG — The specific LAG number to which the forwarding database parameters refer.
• Status — Displays how the entry was created. The possible field values are:
– Permanent — The MAC address is permanent.
– Delete on Reset — The MAC address is deleted when the device is reset.
– Delete on Timeout — The MAC address is deleted when a timeout occurs.
– Secure — The MAC Address is defined for locked ports.