150
Chapter 9: Configuring Multicast Forwarding
IGMP Snooping
SGE2000/SGE2000P Gigabit Ethernet Switch Reference Guide
Chapter
9
IGMP Snooping Page
The IGMP Snooping Page contains the following fields:
• Enable IGMP Snooping Status — Indicates if IGMP Snooping is enabled on the device. IGMP
Snooping can be enabled only if Bridge Multicast Filtering is enabled. The possible field values are:
– Enable — Enables IGMP Snooping on the device.
– Disable — Disables IGMP Snooping on the device.
• VLAN ID — Specifies the VLAN ID.
• IGMP Snooping Status — Indicates if IGMP snooping is enabled on the VLAN. The possible
field values are:
– Enable — Enables IGMP Snooping on the VLAN.
– Disable — Disables IGMP Snooping on the VLAN.
• Host Timeout — Indicates the amount of the time the Host waits to receive a message before it
times out. The default value is 260 seconds.
• MRouter Timeout — Indicates the amount of the time the Multicast router waits to receive a
message before it times out. The default value is 300 seconds.
• Leave Timeout — Indicates the amount of time the host waits, after requesting to leave the IGMP
group and not receiving a Join message from another station, before timing out. If a Leave Timeout
To Next Page
Loading...
