153
Chapter 9: Configuring Multicast Forwarding
Defining Multicast Bridging Groups
SGE2000/SGE2000P Gigabit Ethernet Switch Reference Guide
Chapter
9
– Unchecked — Disables IGMP Snooping on the device.
• VLAN ID — Specifies the VLAN ID.
• Bridge Multicast Address — Identifies the Multicast group MAC address/IP address.
• Ports — Indicates the port number on which Multicast service is configured.
• LAGs — Indicates the LAG number on which Multicast service is configured.
• Of Unit — Displays the stacking member for which the Multicast service parameters are displayed.
• Interface — Displays the interface on which the Multicast service is configured.
• Interface Status — Displays the interface status. The options are as follows:
– Static — Attaches the port to the Multicast group as static member in the Static Row. The
port/LAG has joined the Multicast group statically in the Current Row.
– Forbidden — Forbidden ports are not included the Multicast group, even if IGMP snooping
designated the port to join a Multicast group.
– Non — The port is not part of a Multicast group.
2. Click the Add button. The Add Multicast Group Page opens:
Add Multicast Group Page
The Add Multicast Group Page contains the following fields:
• VLAN ID — Displays the VLAN ID.
• Bridge Multicast IP Address — Displays the IP address attached to the Multicast Group.
• Bridge Multicast MAC Address — Displays the MAC address attached to the Multicast Group.
To Modify a Multicast Group
1. Click Bridging > Bridge Multicast> Multicast Groups. The Multicast Group Page opens:
2. Click the Edit button. The Edit Multicast Group Page
To Next Page
Loading...
Need help?
General
