20
Chapter 2: Managing Device Information
Configuring Units and Ports
SGE2000/SGE2000P Gigabit Ethernet Switch Reference Guide
Chapter
2
Stack Management Page
The Stack Management Page contains the following fields:
• Master Election — Indicates the method of electing the Stack Master device. The possible values
are:
– Automatically — The master is selected automatically by software.
– Force Master — The unit is forced to be master of the stack. Note that only units with the
Unit ID of 1 or 2 can be the stack master.
• Stacking Ports After Reset — Allows the user to decide what cable type is in use. The possible
values are:
– Combo Ports — Indicates that the combo port is used as the stacking port.
– Copper Ports — Indicates that the copper port is used as the stacking port.
• Unit No.— Displays the current Stacking Master.
• Unit No. After Reset — Indicates the stacking member elected Stacking Master after the device is
reset.
2. Define the relevant fields.
3. Click Apply. Stack management is defined, and the device is updated.
To Next Page
Loading...
