50
Chapter 4: Configuring Device Security
Defining Authentication
SGE2000/SGE2000P Gigabit Ethernet Switch Reference Guide
Chapter
4
Edit RADIUS Settings Page
The Edit RADIUS Settings Page contains the following fields:
• IP Address — Displays the RADIUS Server IP address.
• Priority — The server priority. The possible values are 0-65535, where 1 is the highest value. The
RADIUS Server priority is used to configure the server query order.
• Authentication Port — Identifies the authentication port. The authentication port is used to verify
the RADIUS server authentication. The authenticated port default is 1812.
• Number of Retries — Defines the number of transmitted requests sent to RADIUS server before a
failure occurs. The possible field values are 1 - 10. Three is the default value.
• Timeout for Reply — Defines the amount of the time in seconds the device waits for an answer
from the RADIUS server before retrying the query, or switching to the next server. The possible field
values are 1 - 30. Three is the default value.
• Dead Time — Defines the amount of time (minutes) that a RADIUS server is bypassed for service
requests. The range is 0-2000. The Dead Time default is 0 minutes.
• Key String — Defines the default key string used for authenticating and encrypting all RADIUS
communications between the device and the RADIUS server. This key must match the RADIUS
encryption.
• Source IP Address — Defines the source IP address that is used for communication with RADIUS
servers.
• Usage Type — Specifies the RADIUS server authentication type. The default value is Login. The
possible field values are:
– Login — Indicates that the RADIUS server is used for authenticating user name and
passwords.
– 802.1X — Indicates that the RADIUS server is used for 802.1X authentication.
– All — Indicates that the RADIUS server is used for authenticating user name and
passwords, and 802.1X port authentication.
• Use Default — Uses the system default settings.
To Next Page
Loading...
Need help?
General
