Replacing a Copper Twinax SFP+ Transceiver with an Optical SFP+ Transceiver
Procedure
Step 1
Remove the copper Twinax SFP+ from the FEX port by pulling gently on the rubber loop. The cable and
SFP+ transceiver come out as a single unit, leaving the FEX port empty.
Figure 40: Removing a Twinax Copper SFP+ Transceiver
Step 2
Insert the optical SFP+ transceiver into the FEX port. Make sure that it clicks firmly into place.
Step 3
Plug the fiber-optic cable into the optical SFP+ transceiver.
Figure 41: Replacing a Copper SFP+ Transceiver with an Optical SFP+ Transceiver
Cisco UCS 5108 Server Chassis Installation Guide
66
Installation
Replacing a Copper Twinax SFP+ Transceiver with an Optical SFP+ Transceiver
To Next Page
Loading...
