Cisco UCS 5108 Installation Guide

CHAPTER 3
Installing and Removing Components
This chapter describes how to remove components from the chassis and how to install components into the
chassis. This section contains the following section:
•
Components, page 69
•
Installing and Removing a Blade Server, page 71
•
Installing and Removing Power Supplies, page 73
•
Installing and Removing a Power Distribution Unit (PDU), page 75
•
Installing and Removing a FEX or Fabric Interconnect, page 77
•
Migrating to UCS 6300 Series Fabric Interconnects and the UCS 2304 IOM, page 79
•
Installing and Removing a Fan Module, page 82
Components
The following figure shows an empty Cisco UCS 5108 server chassis and identifies the front, back, and module
slots.
Cisco UCS 5108 Server Chassis Installation Guide
69

Cisco UCS 5108 Specifications

General

Number of Blade Slots	8
I/O Module Bays	2
Supported Blade Servers	Cisco UCS B-Series Blade Servers
Power Supply Options	Up to four hot-swappable power supplies (AC or DC)
Cooling	Redundant hot-swappable fans
Management	Cisco UCS Manager
Blade Slots	8
Fabric Interconnects	Cisco UCS 6100 or 6200 Series
Power Supplies	Up to 4 hot-pluggable power supplies
Form Factor	6RU rack-mountable