CITROEN C8 2005 - Tensioning;Dynamic Roller Compressure Lever; Peg for Dynamic Roller 4;2 MM

102
ENGINE
AUXILIARY EQUIPMENT DRIVE BELT
Engines: RHM - RHT - RHW
Tools.
[1] Tensioning lever : (-).0188-J2
[2] Peg for dynamic roller Ø 4 mm : (-) 0188-Q1
[3] Peg for dynamic roller Ø 2 mm : (-).0188-Q2
[4] Dynamic roller compressure lever : (-).1888-Z
(A) Pegging hole
(B) Belt wear check mark (fixed on engine)
(C) Zero wear mark
(D) Maximum wear mark
This marking system permits checking of the belt wear; if the marks (D) and (B) coincide, it implies
that the belt requires replacing.
Tighten the screw (1) to 4,5 ± 0,4 m.daN.
Removing.
Remove:
- The front RH wheel.
- The front RH splash-shield.
- The under-engine shield.
IMPERATIVE: Mark the direction of rotation of the belt if to be re-used.
E5AK0E9C
B3EK0DHD
C8
Angl.T3-page032-190-2005 4/02/05 15:15 Page 102