CITROEN C8 2005 - Measuring the Rear Height H2 M; Adjusting the Heights

318
HYDRAULICS
B3CP06CC
DRAINING - FILLING - BLEEDING: HYDRAULIC SUSPENSION/STEERING CIRCUIT
Measuring the rear height H2M.
The rear height H2M is measured between the ground and the zone "a" on the crossmember.
Calculating the rear height H2C.
Except CARLSSON : H2C = R2 + 68 mm.
CARLSSON : H2C = R2 + 64 mm.
R2 = Radius of rear wheel (mm).
Compare:
- The value measured H2M.
- The value calculated H2C.
Adjust the rear height if necessary.
Adjusting the heights.
Adjustment using a diagnostic tool.
This adjustment is done when the heights measured are within the tolerance of the heights calculated.
Mechanical pre-adjustment.
This adjustment is done when the heights measured are not within the tolerance of the heights calculated
(± 10 mm).
Front height:
- Slacken, by one turn, the screw (1) on the clip (2).
- Retighten the screw by hand.
- To decrease the height, turn the clip (2) towards the front of the vehicle.
- To increase the height, turn the clip (2) towards the rear of the vehicle.
Repeat the operation until you obtain the calculated dimension H1C (± 10 mm).
Tighten the screw (1) to 0,6 m.daN.
Adjust with diagnostic tool [2] or [3].
C5
B3DP08HC
Angl.T3-page300-321-2005 4/02/05 15:33 Page 318