DRAINING - FILLING - BLEEDING: HYDRAULIC SUSPENSION/STEERING CIRCUIT
319
HYDRAULICS
Rear height:
Slacken, by one turn, the screw (3) on the clip (4).
Retighten the screw by hand.
To decrease the height, turn the clip (4) towards the rear of the vehicle.
To increase the height, turn the clip (4) towards the front of the vehicle.
Repeat the operation until you obtain the calculated dimension H2C (± 10 mm).
Tighten the screw (3) to 0,6 m.daN.
Adjust with diagnostic tool [2] or [3].
B3DP08JC
C5
Angl.T3-page300-321-2005 4/02/05 15:33 Page 319
To Next Page
Loading...
