104
ENGINE
C5 AUXILIARY EQUIPMENT DRIVE BELT
Engines: RHL - RHR
B1BP31AD
Tools.
[1] Dynamic tensioner compressure lever : (-).0188.Z
[2] Dynamic tensioner roller retaining peg Ø 4mm : (-).0188.Q1
Removing.
Remove the splash-shield, under-engine sound-deadening, front RH wheel.
WARNING: Mark the direction of fitting of the auxiliaries drive belt in the case of re-use
of the belt.
Compress the dynamic tensioner roller (1) by acting at «b» (anti-clockwise), using tool [1].
Peg using tool [2] at «a».
IMPERATIVE: Check that the roller (1) turns freely (without play and without tight spots).
Refitting.
Refit the auxiliaries drive belt.
IMPERATIVE: Make sure that the auxiliaries drive belt is correctly positioned in the
grooves of the various pulleys.
Compress the dynamic tensioner roller (1) by acting at «b», using tool [1].
Remove tool [2] at «a».
Refit the splash-shield, under-engine sound-deadening, front RH wheel.
Angl.T3-page032-190-2005 4/02/05 15:15 Page 104
To Next Page
Loading...
